G10 Insulation sleeves are made from electrical glass cloth that impregnated with epoxy resin under pressure and heat, with Mechanical and electrical application, good moisture resistance. In accordance with G10 (NEMA standard).
G-10 Glass Epoxy Washer are used for isolation from dissimilar metals & subsequent galvanic corrosion.
VCS very critical service flange insulation gasket kit is a high reliability gasket used for both isolating and general sealing purposes in Very Critical Services.
Neoprene Faced Plain Phenolic Flange Insulation Gasket Kit have been used as standard ''flat'' isolating gaskets in the oil and gas industries for many years. Soft neoprene rubber sheets are factory applied to both sides of a laminated phenolic retainer providing.
Type E Flange Insulation Gasket Kits are designed for full protection of flanges, and have the same outside diameter as the flange. Each gasket has precision-located bolt holes. Upon installation, it is recommended that tape be wrapped around the outside of the flange to prevent foreign material from lodging between the exposed portions and causing "shorting out" of the flanges. All Type E gaskets are easily centered with the flange inside diameter. Gaskets with slightly larger outside diameters are available on request.
Type F Flange Insulation Gasket Kits are designed to fit the raised face portion of flanges. The outside diameter of the gasket is slightly smaller than the inside diameter of the bolt hole circle. The outside diameter is designed for alignment by the insulating sleeves. The central gaskets are available in the same materials as Type E. Upon installation, it is recommended that tape be wrapped around the outside of the flange to prevent foreign material from lodging between the exposed portions and causing "shorting out" of the flanges.